Service Manual, Elna DE Details. Elna Model DE Serger Machine Service Manual, 20 Pages. The physical copy of the instruction manual is a soft cover. Full text of “Elna Serger Instruction Manual dse de e” IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic. Hi there, Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this.
|Published (Last):||27 March 2004|
|PDF File Size:||15.50 Mb|
|ePub File Size:||17.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
Press on the foot control to make 3 to 4 cm of overlock chain, holding the threads on the left. For sewing fluffy or fairly thick fabric, the extra lift 2 mm will be available by swinging the lever c down again. Should it be necessary at any time to re-thread the lower looper, always remove the thread from the needles first, to avoid tangling.
Pass the thread through the guides A to C. Read all instructions before using the machine. Threading the Right Needle – Nanual red on the chart and on the thread guides. Furthermore, your dealer should also be contacted for all technical interventions which are under warranty.
A manual for elna 614DE – Elna Sewing Machines
Posted on Aug 28, Sep 27, Elna Sewing Machines. Lately during the filling cycle water hammer is occurring.
In this case, the fabric might be rolled or the needle thread tension miqht become loose. Hi there, Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Finally thread the right needle from front to back, then under the foot, leaving about 10 cm of the thread to the left.
Unfold the fabric, pull the ends of the thread to the underside and press flat. For spools with a large diameter, place the cone holders higher up on the spool pins or place them with lena widest end on top see illustrationso that the spools can be seated firmly on the spool pin base.
Always replace the bulb with the same type rated 15 Watts maximum. Wipe off any oil remaining around the sewing area. Provide your email address and model I will send it. Unlock the moving blade, refit the side cover and screw cap. Then cut the thread with the thread cutter see illustration.
Raise the presser foot and swing open the lamp cover. Open the front door. A A A Foot Pressure With the guide line a of the pressure control knob even with the top enla surface bthe foot pressure is suitable for most kinds of fabrics and rarely needs adjusting. By pushing the differential 614dd slide c up to a lower number, the front feed dog a moves the fabric more slowly, as shown. Retain them for future reference.
They are needles for domestic use and can also be used with all ordinary household sewing machines. First release Model or loosen the tensions, then pull the looper threads gently behind the needle until the manaul have passed through. The fabric is not moving it just keeps sewing in the same place.
Full text of “Elna Serger Instruction Manual dse de e”
Oct 14, Elna Sewing Machines. With the lower guide line c of the pressure knob at higher level than the top cover surface, lower pressure for very stretchable fabrics is available. However, you can easily change the stitch length by shifting the stitch length slide a between 0.
Have a manual for Elna Sewing Machines? Posted on Jan 02, Elna Mechanical Sewing By using the 2-thread convertor on the upper looper, 2-thread flatlock will be available Model Always store the machine indoors. Cut the thread at both ends of the knots and pass them through the respective eyes of the needles.