Standard [WITHDRAWN] DIN Tribology; testing of friction and wear model test for sliding friction of solids (ball-on-disc system). Buy DIN TRIBOLOGY; TESTING OF FRICTION AND WEAR MODEL TEST FOR SLIDING FRICTION OF SOLIDS (BALL ON DISC SYSTEM) from. Find the most up-to-date version of DIN at Engineering
|Country:||Turks & Caicos Islands|
|Published (Last):||18 May 2014|
|PDF File Size:||4.82 Mb|
|ePub File Size:||7.46 Mb|
|Price:||Free* [*Free Regsitration Required]|
Twist Compression is designed to measure friction and adhesion in metal forming.
Such a use of this standard is encouraged as a means to improve wear testing methodology. The ball is caused to rub against the disk 1mm 503324 at a frequency of 50 Hz for 75 min.
Materials are tested in pairs under nominally non-abrasive conditions. Real time down force controlpiezo sensors to measure inline friction dij this module very reliable and repeatable. Stribeck curve is a plot between coefficient of friction and bearing number.
ASTM G99 – 17 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
Link to Active This link will always route to the current Active version of the standard. Tapping Torque, Twist Compression, Drilling Tapping torque module allows to characterize friction, wear, torque etc. Thank you for your interest and filling out the form!
Work Item s – proposed revisions of this standard.
Historical Version s – view previous versions of standard. Since the pin-on-disk test method does not attempt to duplicate all the conditions that may be experienced in service for example; lubrication, load, pressure, contact geometry, removal of wear debris, and presence of corrosive environmentthere is no insurance that the test will predict the wear rate of a given material under conditions differing from those in the test.
Stribeck Curve Stribeck curve is a plot between coefficient of friction and bearing number. The test setup allows to mount real pieces of actual piston ring and liners.
High-load and high-temperature tribometer
Contact us for a live Demo or additional information. Piston Ring Liner This test helps evaluate friction and wear parameters of piston ring liner material in presence of engine oils. The principal areas of experimental attention in using this type of apparatus to measure wear are described.
Fast Exchange makes all these modules easily swapable on the MFT platform. In all modules listed above user can change the load and velocity to automatically plot Stribeck Curves with ease.
Loads from mN to 10,N. Linear Oscillating The standard Test to determine extreme pressure, friction wear properties of lubricant greases, solid bonded films, gear and hydraulic fluids, lubricating oils. The standard Test to determine extreme pressure, friction wear properties of lubricant greases, solid bonded films, gear and hydraulic fluids, lubricating oils.
It is the responsibility of the user of this standard to establish dln safety and health practices and determine the applicability of regulatory limitations prior to use. All tests are done in oscillation mode under controlled environmental conditions. Temperature and recirculation addons are also available. No other units of measurement are included in this standard.
High-load and high-temperature tribometer – Fraunhofer IST
In this latter case, the results cannot be compared to the ILS data Table 2. The coefficient of friction may also be determined. Referenced Documents purchase separately The documents listed below are referenced within the subject standard ddin are not provided as part of the standard. The value of any wear test method lies in predicting the relative ranking of material combinations.
The tests can be done in controlled environmental 550324 including humidity, temperature and more. This test helps evaluate friction and wear parameters of piston ring liner material in presence of engine oils.
The test involves rotating one ball on three stationary balls at controlled environmental conditions.
However, it must be clearly stated in any report that, while the directions and protocol in Test Method G99 were followed if truethe choices of test parameters were different from Test Method G99 values, and the test results were therefore also different from the Test Method G99 results.
Test involves slowly rotating a ring on top of material of choice.